Power Trust Equipment PTE-7ES Specifications

Power Trust EquipmentPower Trust EquipmentPower Trust EquipmentPower Trust Equipment PTEPTEPTEPTE----7ES7ES7ES7ES Log Splitter Operation ManualL

Hydraulic Oil 2.9liters Capacity: Overall 980mm(length)*275mm Dimensions: (width)*520cm(height)

device. 4. The Log Splitter must be operated by the adults who have read this operation manual only. Anybody not reading this manual is forbidden to u

machine and turn the log by 90 degrees and then start splitting again. If the log can’t be split then, this means the log hardness exceeds the c

If a fine log has knot or the log fiber is too hard, it would be very difficult to split. If the fiber of a bigger log is smooth and loose, the splitt

CHECK BEFORE UNCASING AND INSTALLATIONCHECK BEFORE UNCASING AND INSTALLATIONCHECK BEFORE UNCASING AND INSTALLATIONCHECK BEFORE UNCASING AND INSTALLATI

I. Main body J. Splitting wedge All the screws, bolts, washer and jigs are in the packing box.(The complete list is on the attached parts list). INI

Installation of operating handle Installation of operating handle Installation of operating handle Installation of operating handle Take out the

a nearby truck or other carrier. 2. PrepaPrepaPrepaPrepare the logs for splittingre the logs for splittingre the logs for splittingre the

special Log Splitter platform. If necessary, block the wheels with wedges to prevent them from rolling. 5. Open tOpen tOpen tOpen thhhhe Air Bleede Ai

Warning:Warning:Warning:Warning: If the log does not split immediately,If the log does not split immediately,If the log does not split immediat

Thank you for purchasing this 7-Ton Electric Log Splitter. Please carefully read this operation manual and strictly observe these instructions

 When the supporting feet is blocked,When the supporting feet is blocked,When the supporting feet is blocked,When the supporting feet is blocked,

with the volume specified at page 4 (Be sure to use only clean high quality hydraulic oil specifically made for this purpose). 5. Clean the DIP STICK

TroubleTroubleTroubleTrouble----shootingshootingshootingshooting Problems that may arise when using the log splitter and recommended remedies are g

Log Pusher/Can advances jerkily or with strong upward vibrations Air in the circuit Check oil level. Fill oil if necessary. If problem remains, cont

PPPParts Diagramarts Diagramarts Diagramarts Diagram

Log Splitter Parts ListLog Splitter Parts ListLog Splitter Parts ListLog Splitter Parts List No Name Oty 1 Hexagonal nut(M14)2 2 Hexagonal

20 Nut(M6) 4 21 Screw(M6*14) 2 22/23 Rubber supporter for electrical motor 1 24 Switch dust shield 1 25 Switch 1 26 Switch seat 1 27 Nut(M8

43 Log guiding plate 2 45 Main body 1 46 Plastic sheath plate 2 47 Log pusher assembly 1 48 O-ring oil seal 1 49 Oil cylinder cover-front

PLEASE READ THE FOLLOWING CAREFULLY THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS DIA

repair and change protective device or damaged part as required. 3. Before starting maintenance work, switch off the power and do so even when changin

splitter is turned on, never put the hand onto the motion parts of machine. 12. Never wear ornaments or loose clothes, which can be entangled with th

Symbols used Standard graphic symbols are used on all machines in order to ensure complete safety of all parts of the Log Splitter. As these symbols

animal may be present within a radius of 5 meters of the machine. Dumping of used oil in the environment is forbidden. The oil must be disposed of

SPECLAL WARNINGS WHEN USING THE LOG SPLITTERSPECLAL WARNINGS WHEN USING THE LOG SPLITTERSPECLAL WARNINGS WHEN USING THE LOG SPLITTERSPECLAL WARNIN

shoes and the approved eye protection. Be careful of the splinters that will be produced, to avoid puncture injury and potential jamming of the tool.

of maintaining a small gas engine. Just plug it in and start splitting. 4. Hydraulic RamHydraulic RamHydraulic RamHydraulic Ram. Powerful hydraulic ra